at the heart of drying
at the heart of drying since 1975
INSIDE OUR SYSTEMS
The support structure for the dryer is made from extruded Al-Mg-Si alloy profiles, belonging to category 6005 under standard no. UNI 9006/1, physical state: T6, ultimate tensile strength: 280 mega-Pascal. All parts of the machine – reticular trusses, support columns, crosspieces and braces – are fixed to each other using stainless steel fastening bolts (AISI 304 A2 STAINLESS STEEL).
The subceiling, made from corrugated alloy sheet (EN AW 3105), with a physical state of H18, is installed inside the chamber between the wood and the roof. It channels the flow of air from the ventilators, guaranteeing an even distribution of air between the loads. It comes with a hatch, providing easy access to the motors.
Various heating systems are available: bimetallic heat exchangers that use hot water or superheated water or steam or diathermic oil; gas burners with direct heat exchange (“hot air vein”), gasoil burners with indirect heat exchange (heat exchanger); heat pump (condensation system); pure ventilation (viscous dissipation system).
Insulation of the equipment is guaranteed through panels made from mineral wool or polyurethane foam. Wood drying technology is made using a “sandwich” system with an internal/external corrugated sheet made from embossed natural aluminium. The panels are modular with a tongue-and-groove joint system and guarantee a high level of thermal and acoustic insulation.
The cold water or steam spraying system is provided complete with solenoid valve and removable filter to allow for cleaning. The spray nozzles are made from brass and reinforced plastic and are attached to a stainless steel tube. Spraying guarantees the right hygrometric balance inside the cell and the level of pressure required for the water or steam supply is 3 bar.
The ventilators provided are axial reversible, with symmetrical, aluminium, airfoil blades to guarantee equal performance in the two rotation directions. The motors are hermetically sealed and are built in accordance with the latest IE2 standards, with category F or category H tropicalised insulation, and IP55-grade protection to work in high temperatures and high levels of humidity. For equipment with an internal temperature of over 90°C, we provide motors equipped with an external greasing system.
WOOD DRYING TECHNOLOGY
TO CUSTOMIZED SYSTEM
HEAT RECOVERY UNITS
These pre-heat cold external air, using the hot air that is released and reducing the loss of thermal energy.
These speed up the drying cycle and keep the wood white.
These save on electricity and provide the right amount of ventilation depending on the type of wood.
WALKWAY ON THE ROOF
This allows easy access to the devices on the roof, preventing panels from getting damaged.
These allow for safe access to the roof.
VERTICAL FLAPS AND HORIZONTAL BAFFLES
These allow for optimal air circulation.
DISCOVER THE INCOMAC’S WORLD
DOWNLOAD OUR BROCHURE